![]() ![]() 9 rich color choices Thinnest backlight available at 1.23mm 90% uniformity DMG and Pocket. Then turn your iron down to 200c Ok, we’re ready to attack the screen. Then heat it up with your iron and gently pull the staple out. Some modification to the console is required although its basic enough for any beginner. One end of the staple is soldered to the board, get it good and fluxed up, Place your solder braid on the solder joint and wick away as much solder as possible. /rebates/&252fdmg-gameboy-yellow-backlight. Give your Game Boy a second life with our Game Boy backlights. A Game Boy Backlight display mod from Hand-Held Legend is an easy to use LED panel that fits behind the original Game Boy LCD to light up the screen from behind. It’s actually two mods – fitting an hex inverter, and fitting a backlight kit (from nonfinite electronics), I used the v3 version and it’s very easy to fit, I did need to clean the rear of the screen after removing the reflective film, that was the most difficult bit. I actually prefer this to the GBC Frontlight below. ![]() ![]() Backlighting Your Gameboy DMG – The Right Way Backlight your DMG like a pro! While taking the extra steps to do it right will take more time, and you may encounter a learning curve at first, ultimately, desoldering the screen is the best way, in my opinion, for a few reasons. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |